I really do not do plumbing very well at all. For the last few weeks we have noticed that our water heater has not been heating water very effectively. So I decided that I would do some repairs on it. I went to the store and bought all the parts I thought I would need. I got two elements and a short drain hose, plus an element wrench, and then I proceeded to watch a whole bunch of how-to-do videos on YouTube. After about ten videos, I figured I was an expert.
According to my videos, the first thing I was supposed to do was turn off the power. I did this without any problems. The second thing I had to do was to cut off the water to the water heater. Again no problems. Next it was time to attach the hose to the drain plug. It turns out, this, the simplest part of the task, was the first of my several failures.
When I went to attach the hose to the plastic drain plug, I discovered that the plug was out of shape. Instead of being round, it was an oval shape. No matter what I did I simply could not screw the hose onto the drain plug. After about a half hour of wrestling with the hose, I decided that I would simply let the water out of the water heater slowly and allow it to matriculate across the unfinished basement floor to the drain in the center of the room.
My plan worked perfectly at first. The water slowly drained to the hole with no problems whatsoever. So I went upstairs and took a nap while the water heater drained all the way out. When I woke up an hour later, I went and checked the draining and discovered that it was...still draining. So I waited some more.
Surely after two hours of a steady, controlled flow, I figured that it must be almost done. So I went to work on the upper element. My test indicated that the element was operational, but I decided to change it anyway. I put the special wrench on it and applied increasing force, but the element would not budge. Fused in the socket. It would take some sort of jack-hammer to get it out.
After about 20 minutes, I gave up on that element and went to work on the bottom element. I reasoned that I’d just replace the bottom as it was most likely to be compromised. the wrench quickly broke the crud seal and the element began to back out. That’s when the big disaster struck.
The tank that I thought was empty...wasn’t. Hot water began GUSHING out the hole recently uncorked by the element. Thankfully, it streamed right for the drain, but it kept coming! Obviously not even close to being empty. On and on. I got completely soaked dealing with the mess. After it slowed I finished the job by screwing in the new element and sopping up the water with a wet vac. I simply can’t understand how the heater was not drained.
After turning on the water and burping the system, I turned on the power. It’s been 8 hours, and we have very hot water. So far, there have been no further water disasters.
Editor’s Note: some people rage against others when they call water heaters “hot water heaters”. I suppose they make a fair point that water heaters are made to heat up cold water. However, doesn’t the hot water in the tank also get heated? Therefore, it actually is, at least partially, a hot water heater.
